---------------------------------------------------
【Voltage Compatibility】
Our products are selected to support international voltage ranges (e.g. 100–240V).
However, please make sure your local voltage is compatible before use, as incorrect voltage may still cause malfunction.
【Plug Type】
Our products use Japanese plug types (A or B type).
Please use a conversion adapter if necessary.
【Important Note on Transformers and Adapters】
A transformer adjusts voltage to match your device’s requirements.
A conversion adapter only changes the plug shape and does not adjust voltage.
Using only a conversion adapter without a transformer may result in damage to the product.
【Liability】
We are not responsible for malfunctions or damages caused by improper use, such as operating the product without appropriate voltage or equipment.
---------------------------------------------------
KAUSMEDIA 20W Solar Panel Aluminum Mounting Base
Mounting stand - Single pipe fixing screws x 3
Tapping screws for fixing solar panels x 4
Instruction manual *Single pipes and other tools are not included.
This aluminum mount is designed for KAUSMEDIA's 20W solar panel (18V, aluminum frame). [Material]: Aluminum [Size]: Approx. 295mm W x 190mm H x 115mm D [Weight]: Approx. 689g [Hole Dimensions]: Approx. 49mm *Please note that directly hitting the single-tube may cause it to expand and become unreachable. Please cover the hole with a washer before hitting. *Single-tube pipe (including drive washers, triangles, etc.) and tools (screwdrivers, hammers, etc.) are not included. We ask that you provide these yourself. *The hole locations on the panel may vary depending on the solar panel's manufacturing date. [Installation Instructions] ■For our current solar panel *The holes on the back of the panel will roughly align with the holes on the mount. 1. Align the mount with the mounting holes on the solar panel. 2. Prepare tapping screws and screw them into all four locations. *Caution: Do not overtighten, as this may bend the panel. *Regularly check the tapping screws for looseness. 1. Attach the tip missile to the single pipe and bury the pipe about 40 to 50 cm into the ground.
2. When driving the solar panel into the solar panel, place a drive washer or a wooden board over the pipe before driving it in. * Direct hammering will deform the solar panel and prevent the mounting bracket from fitting. 3. Attach the solar panel to the solar panel so that it faces south. 4. Secure the mounting bracket firmly with the included screws to prevent it from coming loose. ■ For our solar panel (types with different or no hole positions) or solar panels from other manufacturers: * Method: Drill pilot holes in the panel's edge and then use screws to widen the holes. 1. Temporarily place the mounting bracket and drill approximately 1mm holes where the self-tapping screws will be attached. * Use a nail or drill to open the holes, but be careful not to hammer too hard or apply too much force, as this can penetrate the light-receiving surface or bend and damage the panel. For safety, use a backing board or similar. 2. The screw threads will widen as they enter the hole. Once they have widened, remove them and then align the holes with the mounting bracket before attaching it. 3. Fully tighten the self-tapping screws. * Periodically check for looseness. The installation method is up to the customer to decide, but you will need to drill holes on the back side or in a location that will not cause any mechanical problems.
